How To Solve The Air Leakage Phenomenon Of Dust Removal Equipment?

How to solve the air leakage phenomenon of dust removal equipment?
The dust removal equipment is a device that separates the dust from the smoke, also called dust collector or dust removal equipment. Dust removal equipment is the use of underground dust removal water pipe and pressure air pipe, add certain additives in the water, introduce the wind pressure, through special equipment, complete a series of technological processes, foam, through the distributor, sprinkler bracket components to spray on the dust source. Dust removal equipment will also appear the phenomenon of air leakage.
If this phenomenon occurs, then it will cause a series of serious consequences, dust removal equipment is required to work normally when the pulse valve to control, if the phenomenon of air leakage will cause all the pulse valve to stop working due to the pressure can not reach, so that the whole dust removal equipment in a state of paralysis, dust removal for this phenomenon to study, The common reasons are as follows;
1. The diaphragm in the electromagnetic pulse valve is damaged. If this is the reason, we need to replace it.
2. There is a problem with the gasket in the pulse valve, which can not contact with the end face well. It may be that there is rust or some other debris on the end face during the production process.
3. Some of this dust removal equipment uses submerged pulse valve. If there is damage to the blowpipe in this device, the compressed air will be discharged directly and will not enter the next cycle.
Dust removal equipment is a hot-selling product, the importance of pulse valve in these years to fully reflect, although its production technology has been very mature, in practice is still there will be some problems.以上翻译结果来自有道神经网络翻译（YNMT）· 通用场景