The Installation Steps Of Large Rotary Kiln Equipment Are Explained.

The installation steps of large rotary kiln equipment are explained. What are the matters needing attention during installation
With the increasing demand of enterprises for rotary kiln. There are more and more types of rotary kiln. Large rotary kiln equipment can be used to calcination various types of raw materials, and the products produced are also more effective. Therefore, many enterprises are very fond of large rotary kiln, so how to install large rotary kiln equipment? The following rotary kiln manufacturers to teach you.
1. Preparation for construction
In order to ensure the smooth completion of the installation of large rotary kiln equipment, it is necessary to cooperate with the construction unit to accept the foundation of the kiln according to the drawings, calibrate the substandard foundation, clean the impurities, chisel the wool, lay the marking plate, etc. Then carry out the equipment warehouse. The discharge sequence of rotary kiln equipment should be ensured and reasonably placed on the site, so as to avoid the smooth road of the installation site or the chaos of round-trip clearance.
2. Hoisting and leveling
The order of lifting correction is first steel base followed by barrel body, first lifting steel base by parts, then installing on the basis and leveling the elevation. When the steel base is adjusted well, the anchor bolts are kept in the first grouting alignment and the cement mortar pier is maintained to achieve the strength regulation, and then the rigid base is straightened again, and the supporting wheel tile is scraped, hoisted and aligned, and the bearing seat and supporting wheel are found. Straighten the whole supporting wheel group and install the retaining wheel.
Step 3 Weld
After confirming that all the above equipment has been hoisted and grout is in place, the welding of the cylinder can begin. Manual welding and automatic submerged arc welding are usually adopted. After the welding is completed, the weld quality is tested, and then the kiln head cover and sealing structure are installed, followed by the cooling and lubrication system. Then install the burner, do no load debugging and trial run.